Imported V-ribbed belt is particularly suitable for those occasions

The so-called importmulti-wedge belt, is based on a flat belt, on the inner surface is arranged with equal intervals of longitudinal 40 trapezoidal wedge-shaped annular rubber belts, and its working surface is wedge-shaped as the side. Let's understand that the imported multi-wedge belt is especially suitable for those occasions!

The contact area and friction between the V-ribbed belt and the pulley are relatively large, and the load is evenly distributed along the belt edge, so the power transmission force can be further increased. Due to the thin, light, soft and reasonable structure of the belt body, the working stress of the imported polypropylene rope is small and it can work on a smaller pulley. Not only can it be driven from the back of the V-ribbed belt, but also an automatic tension adjuster can be used, so the transmission is safer and more reliable. The imported V-ribbed belt is particularly compact and suitable for applications requiring high transmission power and high-speed operation. It is mainly used for the transmission of power equipment such as engines and motors.

The belt produced by imported V-ribbed belt equipment has excellent performance, high synchronous belt transmission efficiency, heat resistance, oil resistance, wear resistance and long service life. The V-ribbed belt forming drum has a rotating shaft with circumferential and longitudinal axes, a sleeve coaxial with the rotating shaft, the sleeve and the rotating shaft can rotate relative to two angular positions, and the two angular positions determine a specified arc length in two angular directions opposite to the * angular direction. The sliding blocks are arranged at angular intervals to each other in a manner of surrounding the periphery of the rotating shaft, and are rotationally fixed relative to the rotating shaft, the plurality of sliders are mounted so as to be capable of reciprocating in the radial direction. When the rotating shaft and the sleeve are relatively rotated in the angular direction and the two angular directions, respectively, the sliders are rotated with respect to the longitudinal axis.

The benefits of imported multi-wedge belt

1. The contact area and friction between the imported V-ribbed belt and the V-belt are relatively large, and the load is evenly distributed along the bandwidth of the V-ribbed belt, so the transmitted power also becomes larger.

2. The belt body of the V-ribbed belt is thin and light, with good flexibility and reasonable structure, so the stress during work is also reduced, and it can work on a pulley with a small V-ribbed belt.

3. The V-ribbed belt has the characteristics of small vibration, fast heat dissipation, smooth work, and small elongation during transmission, so the V-ribbed belt has a long life. Moreover, the propagation velocity of the V-ribbed belt is relatively large, and the critical linear velocity is also high.

4. The imported V-ribbed belt has high transmission efficiency, remarkable energy saving effect, small space occupation and very compact transmission. In addition, the back of the V-ribbed belt can also be used as a transmission tool, and the use of automatic adjustment tension meter can make the transmission safer and more reliable. The multi-wedge belt is relatively compact and suitable for high-speed transmission with relatively large transmission power.

Below together to understand the importmulti-wedge beltEspecially suitable for those occasions, if you need to know more, you can contact us at any time!

Cut three samples with a length of 250 mm from one PJ V-ribbed belt, and mark a marking line with a spacing of 100mm at the middle position of the PJ V-ribbed belt. When more than three samples cannot be taken from one PJ V-ribbed belt, samples can be cut from the same batch of PJ V-ribbed belt, but must be indicated in the report. 7.4.2 High temperature resistance test method
Place the sample at 100 ℃ ± 2 ℃ for 96 h ± 1 h and then take it out. After standing at laboratory temperature for more than 2h, bend it along a cylinder with a diameter of 20 mm at a contact angle of at least 90 °.